Spangle Pressing Instructions

Pre-heat your press to 300 degrees Fahrenheit.  

Separate the white carrier sheet from the clear sheet that has the spangle dots adhered to it.  On the rare occasion that a spangle dot has shifted use tweezers to place those dots back into the spot they need to be in.  

Lay the clear carrier sheet sparkle side up (sticky side down) onto your garment. 

Press for 5-7 seconds at 300 degrees Fahrenheit. 

When you are finished pressing, remove the garment from the heat press and place it in a place where it can cool off.  

Once your pressed carrier sheet is cool to the touch, meaning NO HEAT is felt, you can begin removing the clear carrier sheet.

Pull firmly.  When pulling make sure you are pulling back onto itself instead of peeling up. Peeling up can cause the spangle prints to loose their sparkle.  

Wait 24 hours before washing!